extra dimension, in the presence of additional large compactified dimensions, it would be possible to produce tiny black holes at future colliders. In this case, we would be able to experimentally test Planck scale physics and the onset of quantum gravity with the Large Hadron Collider (LHC), which is scheduled to start next summer.
The formation of black holes is a fairly robust prediction and one of the most general expectations that one can have, even though the details are still subject to research.
For me, it is quite amazing to see how this field has evolved during the last decade. Starting from a smiled upon speculation, it has by now become a widely accepted scenario for physics beyond the standard model, which is included in simulations of LHC events.
- 1. Micro Black holes in Large Extra Dimensions
- 2. Production of Micro Black Holes
- 3. Evaporation of Micro Black Holes
- 4. Observables of Micro Black Holes
- 5. Further Reading
1. Micro Black Holes in Large Extra Dimensions
In the standard 3+1 dimensional space-time, the production of black holes requires a concentration of energy-density which can not be reached in the laboratory. But in a higher dimensional space-time, gravity becomes stronger at small distances and therefore the event horizon is located at a larger radius. This radius can be so large that we could bring particles closer together than their horizon. A black hole could be created.
The presence of extra dimensions results in a modification of the predictions of the standard model, which become important from a certain energy scale 'the new fundamental scale', and which might be accessible at the LHC. Due to the Heisenberg uncertainty, it requires a large energy to get particles into a small volume. Only energies close by the new fundamental scale would be sufficient to produce a black hole out of this same energy.
For collider physics one is therefore interested in the case where the black hole has a mass close to the new fundamental scale. This corresponds to a horizon radius close to the inverse of the new fundamental scale, which is much much smaller than the radius of the extra dimensions. To a good approximation, this tiny black hole just does not notice that the extra dimensions are compactified, and one can neglect the boundary condition. (The higher dimensional Schwarzschild-metric for this case has been derived by Myers and Perry in '86)
On the other hand, for astrophysical objects we expect to find back the usual 3-dimensional description. In this case, the horizon radius is much larger than the radius of the extra dimensions and the influence of the extra dimensions is negligible.
Those two case are depicted in the figure below. We will be interested in the case depicted on the right side. R is the radius of the extra dimensions (all of them have the same radius) and RH is the horizon radius of the black hole.
2. Production of Black Holes
Let us consider two elementary particles, approaching each other with a very high kinetic energy in the center-of-mass system close to the new fundamental scale. At those high energies, the particles can come very close to each other since their high energy allows a tightly packed wave package despite the uncertainty relation. If the impact parameter is small enough, which will happen to a certain fraction of the particles, we have the two particles plus their large kinetic energy in a very small region of space time. If the region is smaller than the Schwarzschild radius connected with the energy of the partons, the system will collapse and form a black hole.
The production of a black hole in a high energy collision is probably the most inelastic process one might think of. Since the black hole is not an ordinary particle of the standard model, and its correct quantum theoretical treatment is unknown, it is commonly treated as a metastable state, which is produced and decays according to the semi-classical formalism of black hole physics.
To compute the production details, the cross-section of the black holes can be approximated by the classical geometric cross-section Pi R2. A common approach to improve the naive picture of colliding point particles is to treat the creation of the horizon as a collision of two shock fronts in an Aichelburg-Sexl geometry describing the fast moving particles.
Another assumption which goes into the production details is the existence of a threshold for the black hole formation. From general relativistic arguments, two point like particles in a head on collision with zero impact parameter (the b in the figure above) will always form a black hole, no matter how large or small their energy. At small energies however, we expect this to be impossible due to the smearing of the wave functions by the uncertainty relation. This then results in a necessary minimal energy to allow for the required close approach. This threshold is of order of the new fundamental scale, though the exact value is unknown since quantum gravity effects should play an important role for the wave functions of the colliding particles.
Using the geometrical cross section formula, it is now possible to compute the differential and total cross sections for black hole production. This also allows us to estimate the total number of black holes, that would be created at the LHC per year. Inserting the expected technical details for the collider, one finds a number of approximately 109 created black holes per year! This means, about one black hole per second.
3. Evaporation of Black Holes
It was shown by Hawking in '75 that a black hole emits particles with a temperature that is inverse to its mass. This means, the smaller the black hole, the hotter it will be. Since we are talking about really tiny black holes, they are very hot. The typical temperature of the micro black holes is about 200 GeV or 1016 Kelvin!
The evaporation rate (massloss per time) of the higher dimensional black hole can be computed using the thermodynamics of black holes. Once produced, the black holes will undergo an evaporation process whose thermal properties carry information about the number and the radius of the extra dimension. An analysis of the evaporation will therefore offer the possibility to extract knowledge about the topology of our space time and the underlying theory.
The evaporation process can be categorized in three characteristic stages:
To perform a realistic simulation of the evaporation process, one has to take into account the various particles of the standard model with the corresponding degrees of freedom and spin statistics. In the extra dimensional scenario, standard model particles are bound too our submanifold whereas the gravitons are allowed to enter all dimensions. For a precise calculation one also has to take into account that the presence of the gravitational field will modify the radiation properties for higher angular momenta through backscattering at the potential well.
These energy dependent greybody factors can be calculated by analyzing the wave equation in the higher dimensional spacetime and the arising absorption coefficients. A very thorough description of these evaporation characteristics has been given by Kanti in 2004 which confirms the expectation that the bulk/brane evaporation rate is of comparable magnitude but the brane modes dominate.
4. Observables of Black Holes
|One of the primary observables in high energetic particle collisions is the transverse momentum of the outgoing particles, pT (pee-tee), the component of the momentum transverse to the direction of the beam. Two colliding partons with high energy can produce a pair of outgoing particles, moving in opposite directions with high pT but carrying a color charge, as depicted in the figure to the right.|
Due to the quark confinement, the color has to be neutralized. This results in a shower of several bound states, the hadrons, which includes mesons (consisting of a quark and an antiquark, like the pions) as well as baryons (consisting of three quarks, like the neutron or the proton). The number of these produced hadrons and their energy depends on the energy of the initial partons. This process will cause a detector signal with a large number of hadrons inside a small opening angle. Such an event is called a jet.
Typically these jets come in pairs of opposite direction. A smaller number of them can also be observed with three or more outgoing showers. This observable will be strongly influenced by the production of black holes.
To understand the signatures that are caused by the black holes we have to examine their evaporation properties. As we have seen before, the smaller the black hole, the larger is its temperature and so, the radiation of the discussed tiny black holes is the dominant signature caused by their presence. The high temperature results in a very short lifetime such that the black hole will decay close by the collision region and can be interpreted as a metastable intermediate state.
It is apparent that the consequences of black hole production are quite disastrous for the future of collider physics! Once the collision energy crosses the threshold for black hole production, no further information about the structure of matter at small scales can be extracted. As it was put by Giddings and Thomas, this would be ''the end of short distance physics''.
By now, several experimental groups include black holes into their search for physics beyond the standard model. Ideally, the energy distribution of the decay products allows a determination of the temperature (by fitting the energy spectrum to the predicted shape) as well as of the total mass of the object (by summing up all energies). This then allows to reconstruct the fundamental scale, and the number of extra dimensions.
The quality of the determination depends on the uncertainties in the theoretical prediction as well as on the experimental limits e.g. background from standard model processes. Besides the formfactors of black hole production and the greybody factors of the evaporation, the largest theoretical uncertainties turnout to be the final decay and the time variation of the temperature. In case the black hole decays very fast, it can be questioned whether it has time to readjust its temperature at all or whether it essentially decays completely with its initial temperature. Also, the determination of the properties depends on the number of emitted particles. The less particles, the more difficult the analysis.
However, in my opinion the most crucial uncertainty are the latest stages of the evaporation. For hadron colliders like the LHC, the last stages with black hole masses close by the production threshold will dominate the signature, since most of the black holes are actually produced out of parton collisions with a total center-of-mass energy close by even this threshold. In hadronic collisions there are thus very little black holes which actually capture the total available energy of 14 TeV, since the proton's energy gets distributed on its constituents. Such a problem would not be present for a lepton collider.
- Cern Courier: The case for mini black holes
- Jaques Distler: Blackhole Production
- SciAm: Quantum Black Holes
- Not Even Wrong: Black Holes at the LHC
- UniSci: Physicists Hoping To Create Tiny Black Holes At CERN
- Black Holes, an interview with Andreas Ringwald
- Black Holes, an interview with Steve Giddings
- Despite Rumors, Black Hole Factory Will Not Destroy Earth
- Dialogos of Eide: What is Natural?
TAGS: SCIENCE, PHYSICS, BLACK HOLES, LHC